Adding Laundry; Cancelling The Course Of The Cycle . En; Cycle End; Automatic Control Functions - hanseatic HTW7512C Gebrauchsanleitung

To
• interrupt the cycle, press the
In the display, the colon symbol between
the hour and minute display lights up per-
manently.
• continue the cycle, press the
again.
The colon symbol between the hour and
minute display flashes again.

Adding laundry

CAUTION
Risk of scalding!
Improper handling of the appliance
can lead to scalding caused by hot suds.
■ Never force the appliance lid or the
washing drum open.
1. Press the button (10) until the
LED (5) symbol disappears (at least
3 seconds).
The appliance lid is unlocked. The drum
has come to a stop.
2. Open the appliance lid and the washing
drum.
3. Place the laundry items inside.
4. Close the washing drum and the appli-
ance lid.
5. Press the button (10) to continue the
course of the cycle.
Cancelling the course of the
cycle
• To cancel a cycle that is in progress,
switch the appliance off using the
ton (9).
The course of the cycle ends, and the wash
water is drained. When the
pears, you can remove the laundry.
Operation: Standard cycles

Cycle end

button (10).
The appliance stops automatically as soon as
the selected cycle is finished. The display (6)
shows
1. Open the appliance lid (15) and the wash-
button (10)
ing drum (17) and remove the laundry.
2. Leave the appliance lid (15) and washing
drum (17) open so that the appliance can
dry inside.
3. To switch off the appliance, press the
button (9).
If no further setting is made, the appliance
will automatically switch off after 15 minutes.
4. Turn the tap off.
5. Disconnect the mains plug from the socket.

Automatic control functions

The following functions run automatically. You
cannot change them.
– Foam detection
The electronic foam detection makes sure
that more water is added to the first rinse
cycle for certain amounts of foam.
– Overflow protection system
This system prevents water from escaping
via the dispenser. As soon as a certain wa-
ter level is exceeded, the outlet pump will
automatically switch on.
– Dynamic quantity control
If your appliance is only loaded up to a
maximum of half its maximum capacity,
the water consumption and cycle dura-
tion will be reduced for some cycles. Ad-
just the detergent dosage accordingly.
The cycle starts as soon as the appliance
has determined the amount of laundry (ap-
prox. 1 minute).
– Imbalance correction system
but-
This system protects your appliance in the
event of a too-great imbalance once spin-
ning starts. This can happen with small
LED disap-
loads or with large individual pieces of
laundry. The laundry is distributed again
and the spin speed increased if the laundry
distribution is right.
endE
and the LED disappears.
Page EN-19