Creating An Electrical Connection - hanseatic HWMB814C Gebrauchsanleitung

Creating a water inlet
NOTICE
Risk of damage to property!
Improper handling of the appliance
may result in damage.
■ Only use the hose delivered with the
appliance to connect to the water
supply. Never use old hoses.
■ ATTENTION: Do not connect the ap-
pliance to the hot water supply.
■ Only connect the appliance to a wa-
ter supply with an inlet water pressu-
re between 0.05 MPa and 1.0 MPa
(0.5 to 10.0 bar). For higher water
pressure, a pressure regulator needs
to be installed. Enquire about the wa-
ter pressure with the water authority.
■ Do not use a pipe wrench to screw
down the union nuts on the tap. This
can damage the union nuts.
For the water supply, you will need a tap with
a 3/4 inch screw connection.
1. Screw and tighten the water inlet hose (b)
onto the connecting nozzles (13) by hand.
To do so, turn the union nut (40) clock-
wise.
Set-up and connection
2. Secure the other end of the water inlet
hose to the tap by hand. To do so, turn the
union nut (41) clockwise.
3. Open the tap completely and check
whether the connections on the appliance
and on the tap are sealed.
4. Then close the tap again.
Creating an electrical
connection
WARNING!
Risk of electric shock!
Touching live parts may result in severe
injury or death.
(13)
■ Do not put into operation if the
(40) mains cord is faulty or the appliance
displays other visible damage.
■ Do not operate the appliance with an
external timer or a separate remote
control system.
(b)
Page EN-35
(41)