hanseatic HWMB814C Gebrauchsanleitung Seite 82

Page EN-38 Troubleshooting table
Wash result is not satisfactory
Problem
Detergent residue on
laundry.
Colours of the laundry
have faded.
Malfunction
Problem
Appliance does not
work.
Wash cycle does not
start.
Appliance is not receiv-
ing water.
E10
(error code on the
display)
Water is not being
pumped out.
Water is draining even
though the appliance is
not pumping.
Possible causes
Too much detergent used.
Detergent contains bleaching
agent.
Stain remover or similar was used.
Possible causes
Mains plug is not inserted properly
in the socket or is not connected.
Socket has no voltage.
Fuse is not intact.
The appliance door is not properly
E30
closed (error code
play).
Cycle was not started.
The appliance calculates the
amount of laundry (approx.
1 minute).
Tap is closed.
Inlet hose is kinked.
Inlet hose is clogged.
Filter at the inlet is clogged.
Outlet hose is clogged or kinked.
The lint trap is clogged.
Outlet hose is too low.
Solutions, tips
Use the amount of detergent rec-
ommended by the manufacturer for
the water hardness in your area.
Use colour freshener if necessary
(available at chemist's). In future,
use detergent without bleaching
agent.
Solutions, tips
Insert the mains plug into the sock-
et properly.
Check fuse; switch on if necessary.
Replace fuse.
Close the door properly until you
on the dis- hear a "click".
Press the
The program cycle starts as soon
as the appliance has determined
the amount of laundry.
Open tap.
Check inlet hose; dismantle and re-
align, if necessary.
Clean filter in the inlet hose (see
page EN-29).
Clean filter at the inlet (see
page EN-29).
Check outlet hose; dismantle and
realign, if necessary.
Clean the lint trap (see "Cleaning
the lint trap" on page EN-30).
Place outlet hose higher.
button (9).