Installation - pyrexx PX-1 Betriebsanleitung

4.4 Rooms with a platform or gallery
>16 m² / >2 m
0,5 0,5
Fig. 7 Rooms with a platform or gallery
Allowed
Not allowed
Note the following for rooms with plat-
f o r m s o r g a l l e r i e s ( a r e a g r e a t e r t h a n
16 m , at least 2 m long and wide):
2
f Mount an additional device under the
platform/gallery.
44
1/2 1/2
0,5
Operating Manual: PX-1 - Smoke Alarm Device
5

Installation

The device is held by a magnet carrier at the
installation location. The magnet carrier can be
mounted by gluing or drilling. To avoid injuries
from improper
installation, the instructions in this manual must
be followed. The general safety regulations
should also be observed.
CAUTION
Possible property damage!
Using other fastening material (not
enclosed) or wrong conditions at the
installation location can cause the device
to fall down.
f For adhesive mounting, use only the
supplied mounting material (adhesive
pad).
f For drill mounting, use screws and
dowels that are suitable for the
respective surface.
f Ensure that the installation location
is strong enough, solid, dry, free from
grease, dust and loose paint etc.
f Note that the magnet carrier magneti-
cally attracts only from one side.