General Safety Instructions For Power Tools - Parkside PHSL 900 A3 Originalbetriebsanleitung

GB IE
If an accident or fault occurs during op-
eration, immediately switch off the device
and disconnect at the plug. Treat injuries
appropriately or consult a doctor. For the
correction of faults, read the "Troubleshoot-
ing" chapter or contact our service centre.
RESIDUAL RISKS
Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this electric
tool may present the following hazards:
a) Cuts
b) Ear damage if working without ear pro-
tection.
c) Damage to your health caused by swinging
your hands and arms when operating the
appliance for longer periods of time or if
the unit is not held or maintained properly.
General safety instructions
for power tools
WARnInG! Read all safety
directions and instructions.
Omissions in the compliance with
safety directions and instructions
can cause electrical shock, fire
and/or severe injuries.
Retain all safety directions and in-
structions for future use.
The term "Power Tools" used in the safety
instructions refers to mains-operated power
tools (with power cord) and to battery-op-
erated power tools (without power cord).
1) Work area safety
a) Keep work area clean and well
lit. Cluttered or dark areas invite ac-
cidents.
26
b) Do not operate power tools in
explosive atmospheres, such as
in the presence of flammable
Iiquids, gases or dust. Power tools
create sparks which may ignite the
dust or fumes.
c) Keep children and bystanders
away while operating a power
tool. Distractions can cause you to
lose control.
2) Electrical safety
a) Power tool plugs must match
the outlet. never modify the
plug in any way. Do not use
any adapter plugs with earthed
(grounded) power tools. Unmodi-
fied plugs and matching outlets will
reduce risk of electric shock
b) Avoid body contact with
earthed or grounded surfaces,
such as pipes, radiators, ranges
and refrigerators. There is an
increased risk of electric shock if your
body is earthed or grounded.
c) Do not expose power tools to
rain or wet conditions. Water
entering a power tool will increase the
risk of electric shock.
d) Do not abuse the cord. never
use the cord for carrying, pulling
or unplugging the power tool.
Keep cord away from heat, oil,
sharp edges or moving parts.
Damaged or entangled cords increase
the risk of electric shock.
e) When operating a power tool
outdoors, use an extension cord
suitable for outdoor use. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
f) If operation of the power tool
in a damp environment is una-