General Notes On Safety; Residual Risks; General Safety Instructions For Power Tools - Parkside PTHSA 20-Li A2 Originalbetriebsanleitung

Wear anti-slip safety shoes.
Keep persons in the vicinity away
from the device.
Do not use the hedge trimmer in the
rain or on wet hedges.
Danger of death by electrocution!
10 m
Keep at least 10m away from
power lines.
Caution! Falling objects. Particu-
larly when cutting overhead.
Caution! Risk of injury from blades
in operation.
410 mm
Cutting length
Remove the battery prior to servic-
ing the appliance.
Information of the acoustic power
level L in dB.
WA
Electrical machines do not belong
with domestic waste.
Parkside X 20 V TEAM

General notes on safety

Before working with the equipment,
familiarise yourself with all operating
components. Practice handling the
equipment and have the function,
operation and working methods
explained to you by an experienced
user or specialist. Ensure that you can
shut off the equipment immediately in
an emergency. Inappropriate use of
the device may result in serious injury.
In the event of an accident or malfunction
during operation, switch off the device
immediately and remove the battery from
the device or pull out the mains plug. Treat
injuries appropriately or consult a doc-
tor. For the correction of faults, read the
"Trouble Shooting" chapter or contact our
service centre.

RESIDUal RISkS

Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this electric
tool may present the following hazards:
a) Cuts
b) Ear damage if working without ear
protection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
General safety instructions
for power tools
WARNING! Read all safety
directions and instructions.
Omissions in the compliance with
safety directions and instructions
can cause electrical shock, fire
and/or severe injuries.
Retain all safety directions and in-
structions for future use.
The term "Power Tools" used in the safety
instructions refers to mains-operated power
tools (with power cord) and to battery-op-
erated power tools (without power cord).
IE NI
7