Intended Use; General Description; Extent Of Delivery; Overview - Parkside PHSL 900 A3 Originalbetriebsanleitung

Intended Use

The equipment is specified for use only for
the cutting and trimming of hedges, bushes
and ornamental shrubs in the domestic
environment. Any other use that is not ex-
plicitly approved in these instructions may
result in damage to the equipment and
represent a serious danger to the user.
The equipment is designed for use by
adults. Adolescents over the age of 16
may use the device only under supervision.
Local regulations may specify an age limit
for the user. Do not use the hedge trimmer
in the rain or on wet hedges.
The operator or user is responsible for ac-
cidents or damage to other people or their
property. The manufacturer is not liable
for damages caused by unspecified use or
incorrect operation. This equipment is not
suitable for commercial use. Commercial
use will invalidate the guarantee.
Before use, check that the blades
are sharp. Ensure that the blades
are sharpened whenever blunt,
in order to avoid overstressing of
the machine. Damages caused by
cutting with blunt blades are not
covered by the guarantee.

General Description

The illustration of the principal func-
tioning parts can be found on the
front and back foldout pages.

Extent of delivery

- Long-handled hedge trimmer (three-part)
- Blade protection
- Shoulder strap
- Round handle
- Protective goggles
- 3 x star knob
- Instruction manual

Overview

1 Safety blade
A
2 Gearbox
3 Safety lever
4 Stop lever
5 Handle for adjusting the blade
beam
6 Front tubular shaft
7 Safety button, front tubular shaft
8 Pivotal centre,
middle tubular shaft
9 Middle tubular shaft
10 Safety button,
middle tubular shaft
11 Pivotal centre, extension tube
12 Tubular shaft on the appliance
housing
13 Round handle, front handle
14 Safety slide
15 Safety switch
16 On/off switch (not visible)
17 Mains cable
18 Cable strain relief
19 Shoulder strap
20 Eye (for shoulder strap)
21 Blade protection
22 Protective goggles
B 23 Covering cap
24 Counter-holder
C
25 Washer (pivotal centre round handle)
26 Pivotal centre (round handle)
27 Soft grip
28 Screw, carrying eye
29 Keyhole bore
GB IE
23