Operation - Silvercrest SDI 3500 D4 Bedienungsanleitung

Operation

CAUTION! DAMAGE TO APPLIANCE!
► Make sure that the total weight of the pan (including contents) does not
exceed 10 kg, as this could damage the induction fields 1/3.
► Do not pull the mains plug out of the mains socket until the fans have
stopped working, as this could damage the appliance.
NOTE
► The cooker beeps every time you make an entry.
1) Place a suitable pan with contents in the middle of one of the induction
fields 1/3.
2) Insert the plug into the mains power socket.
All the control lamps light up briefly. The appliance is now in standby mode.
The display t shows "
less than 60°C.
If a cooking process has already taken place and the induction field 1/3
temperature is still above 60°C, the display t will read "
3) Press the On/Off button
"
NOTE
If you do not place a suitable pan on the induction fields 1/3 or make
►
any settings within 30 seconds, the appliance will beep and switch to
standby mode.
4) You can use the power level mode or the temperature level mode to cook.
To do so, press the Mode button
In power level mode, the preset power level appears on the display t (for
the left induction field 1 "
control lamp
In power level mode, the pan is heated at varying speeds. The higher the
selected power level, the faster the pan is heated.
In temperature level mode, the preset temperature of
display t. The control lamp
You can raise or lower the temperature in increments of 10°C by using the
When you are cooking in temperature level mode, the appliance heats the
pan to the set temperature. As soon as the temperature falls below the set
temperature, the appliance heats up again. The temperature is thus main-
tained at the desired level.
SDI 3500 D4
" appears on the display t and the On/Off control lamp 0 lights up.
7 lights up.
r or z button.
" if the temperature of the induction field 1/3 is
q.
e.
", for the right induction field 3 "
8 lights up.
".
"). The
°C appears on the
GB │ MT │ 53 ■