Setting Up And Connecting; Operation - Silvercrest SDK 2500 A1 Bedienungsanleitung

CAUTION - RISK OF FIRE!
GB
CY
Never leave the appliance unattended while it is being used.
►
When the appliance is in use ensure that there are no easily infl ammable
►
materials close to it (e.g. dishcloths, oven cloths etc.).
If you do not intend to use the appliance for an extended period, you must
►
disconnect it from the power source. The appliance is only completely with-
out current when the power plug has been pulled out of the socket.

Setting up and connecting

Operation

The relevant indicator lamp 5/6 for the cooking plate 1/2 you have switched on
illuminates.
If you do not intend to use the appliance for an extended period, remove the plug from
the power socket.
6
1) Place the appliance on a stable, level and heat-resistant surface.
2) Insert the plug into a mains power socket.
3) Switch the appliance on by switching the On/Off switch 3 to the position "I".
4) Switch both cooking plates 1/2 to MAX and allow these to heat up for around
3 minutes without a saucepan.
This can cause slight smoke development since the protective coating which has
been applied will burn in. Ensure there is suffi cient ventilation. For example, open
a window.
NOTE
► Use cooking utensils with fl at, even bases for better thermal transfer.
► If possible, use cooking utensils which match the cooking plate sizes.
1) Place the fi lled saucepan on the required cooking plate 1/2.
2) Switch the appliance on by sliding the On/Off switch 3 to the position "I".
3) Turn the relevant thermostat 4/7 to the required setting:
▯ 0 - 4: slow cooking
▯ 4 - MAX: fast cooking
4) Once the cooking process has fi nished, adjust thermostat 4/7 back to MIN.
The indicator lamp 5/6 goes out.
5) Turn the On/Off switch 3 to "O".
SDK 2500 A1