Changing The Attached Tool; Place A Sanding Sheet On The Backing Plate; Bringing Into Use; Switching On / Off - Parkside PMFW 310 B 1 Bedienungs- Und Sicherheitshinweise

B
HCS
Segment saw blade Z85 B3
Material:
Wood
Use:
· Cutting and plunge sawing
· Close to the edge sawing, even in difficult to
access areas
Example: Laying parquet and other floor coverings,
including plunge sawing. (see Figs. C, E and F)
Scraping knife Z52 A2
9
Materials: Mortar / concrete residues, tile / carpet
adhesives, paint / silicone residues
Use:
· Removal of material residues, for example tile
adhesive when replacing damaged tiles
(see Fig. I)

Changing the attached tool

Q
NoTE: If you would like to use the vacuum dust
extraction device, you must connect it before attach-
ing or changing the attachment (see section on
"Connecting a vacuum dust extraction device").
DANGER oF INJURY! Pull
the mains plug out of the mains socket
before you carry out any task on the
electrical power tool.
All manuals and user guides at all-guides.com
Assembly / Bringing into use / Maintenance and cleaning
8
Q
Q
Q
Q
NoTE: The required oscillation speed depends on
the material and the working conditions and can
be determined by means of a practical test.
Q
R emove any tool already inserted. To do this,
release the clamping screw
key and take off the tool.
11
P lace the tool (e.g. plunge saw blade
the tool mount.
NoTE: You can place the tool in any of the
possible positions on the tool mount.
F asten the tool in place with the clamping
screw and clamping plate
10
clamping screw using the Hex key
10
C heck that the tool is firmly seated.
Incorrectly or insecurely attached tools could
become lose during use and injure you.
Place a sanding sheet
on the backing plate
O ffer up the sanding sheet
one side of the backing plate
the sanding sheet to the backing plate.

Bringing into use

Switching on / off

S lide the ON / OFF switch
switch on the device.
S lide the ON / OFF switch
switch off the device.

Selecting the oscillation speed

P reselect the required oscillation speed using
the oscillation speed setting wheel

Maintenance and cleaning

DANGER oF INJURY! Pull
the mains plug out of the mains socket
before you carry out any task on the
electrical power tool.
using the Hex
10
) on
6
. Tighten the
4
.
11
to fit flushly on
12
, then apply
7
forwards to
1
backwards to
1
.
2
GB 11