Changing The Attached Tool; Place A Sanding Sheet On The Backing Plate; Bringing Into Use; Switching On / Off - Parkside PMFW 280 A2 Bedienungs- Und Sicherheitshinweise

· Close to the edge sawing, even in difficult to
access areas
Example: Sawing of recesses in lightweight walls.
(see Figs. B and D)
Backing plate
Materials:
Wood (sanding sheets included), paint*, stone*
*depending on the sanding sheet
Use:
· Sanding at edges and in difficult to access areas
(see Figs. G and H)
Segment saw blade
Material:
Wood, metal
Use:
· Cutting and plunge sawing
· Close to the edge sawing, even in difficult to
access areas
Example: Laying parquet and other floor coverings,
including plunge sawing. (see Figs. C, E and F)
Scraping knife
Downloaded from www.Manualslib.com
7
8
9
manuals search engine
Assembly / Bringing into use
Materials: Mortar / concrete residues, tile / carpet
adhesives, paint / silicone residues
Use:
· Removal of material residues, for example tile
adhesive when replacing damaged tiles
(see Fig. I)

Changing the attached tool

Q
NoTE: If you would like to use the vacuum dust
extraction device, you must connect it before attach-
ing or changing the attachment (see section on
"Connecting a vacuum dust extraction device").
DANGER oF INJURY! Pull
the mains plug out of the mains socket
before you carry out any task on the
electrical power tool.
Remove any tool already inserted. To do this,
release the clamping screw
key and take off the tool.
11
Place the tool (e.g. plunge saw blade
the tool mount.
NoTE: You can place the tool in any of the
possible positions on the tool mount.
Fasten the tool in place with the clamping
screw and clamping plate
10
clamping screw using the Allen key
10
Check that the tool is firmly seated.
Incorrectly or insecurely attached tools could
become lose during use and injure you.
Place a sanding sheet
Q
on the backing plate
Offer up the sanding sheet
one side of the backing plate
the sanding sheet to the backing plate.

Bringing into use

Q

Switching on / off

Q
Slide the ON / OFF switch
switch on the device.
using the Allen
10
) on
6
. Tighten the
4
.
11
to fit flushly on
12
, then apply
7
forwards to
1
GB/IE 11