Checking The Battery Charge Level; Recharging The Battery; Motor Unit With Drill Attachment Pkga1; Changing The Tool - Parkside PKGA 20-Li C2 Originalbetriebsanleitung

GB IE
By using the on/off switch (
can progressively control the speed.
Gentle pressure: low speed
Increase pressure: higher speed.
2. Switching off: Release the on/off
switch ( 10).
If you place the direction switch
( 7) in the middle position, the de-
vice is secured against being switched
on.
Checking the battery
charge level
The battery's (
ed by the charge state indicator (
• The charge level of the battery is
indicated by illumination of the corre-
sponding LED lights while the device is
in operation. Press and hold the power
button to view.
red-yellow-green => Battery fully charged
red and yellow
=> Battery half charged
red
=> Battery needs
Charge the battery (
only the red LED on the level indica-
tor is illuminated.

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (9) when
the red LED on the charge status
indicator (9a) is on.
1. Remove the battery (9) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
36
10) you
9) charge level is indicat-
to be charged
9) when
2. Insert the battery (9) in the charging
compartment of the battery charger
(14).
3. Plug the battery charger (14) into a
mains outlet.
4. When the battery is fully recharged un-
plug the battery charger (14) from the
mains.
5. Remove the battery (9) from the charg-
er (14).
Overview of the control display on
the charger (14):
Green LED lights up without battery in-
serted: Charger ready.
9a).
Green LED lights up: Battery such alleged
charged.
Red LED lights up: Battery charging.
Motor unit with drill
attachment PKGA1

Changing the tool

Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
1. Rotate the keyless chuck (1) towards
RELEASE
large enough to accommodate the tool.
2. Insert the tool as far as possible into
the keyless chuck (1).
3. Turn the keyless chuck towards
order to clamp the tool.
4. To remove the tool again, rotate the
keyless chuck (1) towards
the drill chuck aperture is large enough
to remove the tool.
until the drill chuck aperture is
in
GRIP
RELEASE until