Sharpening The Cutting Teeth; Changing The Saw Chain; Maintaining/Turning The Blade Bar; Replacing The Spool - Parkside PGKGA 40-Li B2 Originalbetriebsanleitung

Sharpening the cutting teeth

Have the saw chain sharpened by a spe-
cialist, or proceed in accordance with the
operating manual for your saw chain shar-
pening device. Sharpening a saw chain
requires some practice. Replacing the saw
chain is preferable in case of doubt.

Changing the saw chain

Never attach a new saw chain
onto worn teeth, or onto a dama-
ged or worn blade bar.
1. Switch off the device and remove the
batteries.
2. Release the nut (
the chain wheel cover (
3. Remove the old saw chain (
The mounting and tensioning of the new
saw chain is described in the "Assembly -
Tensioning the saw chain" section.
Maintaining/turning the
blade bar
The blade bar has to be reversed every
8-10 operational hours in order to ensure
even wear.
1. Switch off the device and remove the
batteries from the device.
2. Release the nut (34) and remove the
sprocket cover (33). Remove the saw
chain (1) and the blade bar (35).
3. Check the blade bar (
Remove burrs and straighten the guide
surfaces with a fl at fi le.
4. Clean the oil passage (
sure fault-free, automatic oiling of the
saw chain during operation.
34) and remove
33).
1).
35) for wear.
61) to en-
5. Turn the blade bar (35) once along its
horizontal axis.
6. Place the saw chain (1) into the blade
groove. Place the saw chain (1) into
the chain sprocket (36).
7. Place the blade (35) and saw chain
(1) on the coach screws (37). When
the nose on the right below the coach
screw (37) sits in the lower round re-
cess on the blade bar, the blade bar
is placed correctly. It is normal for the
saw chain (1) to sag.
8. Pre-tension the saw chain (1) by turning
the screw (38) to tension the chain in
a clockwise direction. Also see section
"Tensioning the saw chain".
9. Place the sprocket cover (33) into posi-
tion. Tighten the nut (34) of the socket
cover.

Replacing the spool

1. Remove the rechargeable batteries.
2. Place the device on the ground in a
stable position.
3. Block the mounting spindle (
using the hexagon socket wrench
( 22) as depicted.
Screw the spool cap (17) clockwise
to the mounting spindle (
4. Open the spool cap (17) by fi rmly
pressing the quick-release catch (56)
inwards on both sides of the spool cap
(17), and remove the spool cap cover.
5. Place the new spool (57) into the spool
cap cover (17) and insert the two ends
of the thread through the thread outlets
(58). Loosen the two thread ends from
the grooves (
6. Place the spool (57) inside the lid of
the spool cap (17) and reassemble the
lid and base.
7. Screw the spool cap (17) anticlock-
wise back onto the mounting spindle (
GB
52)
52).
60) on the spool.
IE
67