Troubleshooting; Troubleshooting Table - hanseatic MC-IF7021B2 Gebrauchsanleitung

Troubleshooting

Troubleshooting table

Problem
The appliance cannot be
switched on, the sensor
field doesn't display
anything.
The sensors do not
react.
The sensors respond
poorly.
Fissures or cracks in the
appliance.
The cookware makes
a crackling or whirring
noise.
The cookware emits a
whistling sound when on
a high heat setting.
Fan noise.
The cookware does
not heat up and the
message " " appears on
the display.
The appliance switches
off unexpectedly. You
will hear a beep and an
error message (usually
a flashing timer display)
will appear in the sensor
field.
Possible solutions/tips
The power supply has been interrupted. Check the fuse for the
cooker in the domestic fuse box. If you have any concerns, contact
our Service Centre (see "Service" on page EN-27).
The child safety device is switched on. Switch the child safety
device off (see "Adjusting the safety locking mechanism" on
page EN-18).
A film of water is covering the sensor, or you did not touch the
sensors with your entire fingertip. Clean and dry the sensor field,
and always touch the sensor with the entire fingertip and not just
the very end of the finger.
WARNING!
Risk of short circuiting and electric shock!
The appliance operates with dangerous voltages.
■ Disconnect the appliance from the power supply immedi-
ately (turn off or unscrew fuses)!
■ Call our Service Centre (see "Service" on page EN-27).
These noises arise due to the design of the induction cookware and
do not indicate a defect.
These noises arise due to the design of the induction cookware
and do not indicate a defect. If you reduce the heat setting, these
noises should stop.
The appliance is equipped with a fan, which switches on
automatically when one of the cooking zones is activated and
continues to run for some time after the hob has been switched off.
Do not turn off the power supply to the appliance while the fan is
running.
The induction hobs do not recognise the cookware because it is
not suitable for induction hobs. Select suitable cookware (see "The
right cookware" on page EN-12).
The induction hob does not recognise the cookware because it is
too small for the selected cooking zone or because it is not centred
on the cooking zone.
Technical error. Make a note of the error message on the sensor
field, disconnect the appliance from the power supply and contact
our Service Centre (see "Service" on page EN-27).
Troubleshooting Page EN-25