Safety Notices - hanseatic MC-IF7021B2 Gebrauchsanleitung

Page EN-4 For your safety

Safety notices

In this chapter, you will fi nd general
safety notices which you must always
observe for your own protection and
that of third parties. Please also ob-
serve the warning notices in the individ-
ual chapters on operation, set-up, etc.
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■ Only use the appliance indoors. Do
not use in wet rooms or in the rain.
■ Do not operate or continue to oper-
ate the appliance, if
– it shows visible signs of damage,
for example, the connection cable
is defective;
– starts smoking or there is a burning
smell;
– it makes unusual sounds.
In such cases, switch off the circuit
breakers/unscrew fuses and contact
our Service Centre (see "Service" on
page EN-27).
■ Connection to the mains supply may
only be made by an authorised elec-
trician approved by the local energy
supply company (see "Service" on
page EN-27). Only then will you bene-
fi t from our warranty and a suffi cient
level of safety. Unauthorised persons
may not connect the appliance to
the mains supply. You can endanger
your life and that of subsequent us-
ers! This also applies to disconnection
from the power supply and disman-
tling the old appliance.
■ The appliance is designed for alter-
nating voltage 220–240 V~ / 380–
415 V 3N~ / 50 Hz. The appliance
may be connected only to a pre-in-
stalled mains cable of type H07RN-F
with a conductor cross-section of at
2
least 5 × 1.5 mm
current of a maximum of 16 A.
■ Keep the mains plug and mains cord
away from naked fl ames and hot sur-
faces.
■ Do not kink or pinch the mains cord
or lay it over sharp edges.
■ If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualifi ed
persons in order to avoid a hazard.
■ Since all poles of the appliance can-
not be disconnected from the mains
via an accessible disconnecting de-
vice, an all-pole disconnecting device
in accordance with overvoltage cat-
egory III must be connected within
the house installation with at least
3 mm contact clearance.
■ Before connecting the appliance,
switch off the relevant power circuit
or turn off the relevant fuses. Before
accessing the terminals, all supply cir-
cuits must be switched off.
■ Do not extend or amend the power
cord.
■ Never open the housing.
■ Never repair a defective or suspected
defective appliance yourself. You can
put your own and future users' lives
in danger. Only authorised specialists
are allowed to carry out this repair
work.
■ The appliance is not intended to be
operated by means of an external
timer or a separate remote-control
system.
and with a rated