Troubleshooting Table - hanseatic HBCO7010PA1 Gebrauchsanleitung

Troubleshooting table

Malfunctions can occur in all electrical appliances. This does not necessarily mean there is a
defect in the appliance. For this reason, please check the tables to see if you can correct the
malfunction.
WARNING
Risk of electric shock in case of improper repair!
Never try to repair a defective or suspected defective appliance yourself. You can put
your own and future users' lives in danger. Only authorised specialists are allowed to
carry out this repair work.
Problem
The oven and cooking
zones are not working
and nothing is shown on
the display.
The heat symbol will
disappear.
The cooking
compartment light is
defective.
The cooking chamber
door cannot be closed
properly.
Fissures or cracks in the
hob.
The external cooling
fan is not working; no
air released from the air
locks and Cover is very
hot.
External cooling fan
keeps running.
Possible solutions/tips
The power supply has been interrupted. Check the fuses for the
oven on the fuse box. In case of doubt, please contact our Service
Centre (see page EN-40).
The set oven temperature has been reached. The heat symbol will
automatically re-appear as soon as the oven re-heats.
Replace the defective bulb for the cooking compartment light (see
"Replacing oven lightbulbs" on page EN-31). Notice: Defective bulbs
do not fall under our warranty.
Foreign objects are located on the door seal faces. Clean the door
seal faces thoroughly.
The cooking compartment door is warped or the door seals/latch
is defective. Do not use the appliance! Please contact our Service
department regarding this.
Switch off all cooking zones immediately and stop using them.
Contact our Service team (see page EN-40).
Switch on just the cooking compartment lighting – if there is no fan
noise and no air is being released, the fan is defective.
CAUTION!
Risk of burns!
■ In such an event, immediately open the oven door, switch
off the appliance, and stop using the cooker! Contact our
Service Centre (see page EN-40).
No error. The external cooling will run for a while and then shut off
automatically.
Troubleshooting table
Page EN-39