Installing The Appliance - hanseatic MC-IF7021B2 Gebrauchsanleitung

– At the back of the fixing plate, a square
opening with sides of at least 80 mm must
be cut out.
– If the appliance is installed over an oven
with ventilation, the clearance between the
base of the appliance and the cover of the
oven must be at least 50 mm.
– At the front of the appliance, there must be
an air outlet measuring at least 5 mm be-
tween the appliance and the oven or floor
unit.
– Veneers, plastic coverings and adhesives
used must be heat-resistant up to 100 °C.
Air outlet
Air outlet
– The appliance must be positioned in such
a way that the air outlet is not obstructed.
590 mm
60 mm
56 mm
>50 mm
490 mm
>50 mm
1. Cut a recess in the worktop: 560 ×
490 mm (W × D).
If a hob was already installed, the recess
cut for it must have the same dimensions.
520 mm
>50 mm
560 mm
>50 mm
Installation

Installing the appliance

1. Take the appliance out of the packaging.
2. Remove all protective and packaging ma-
terials.
3. Turn the appliance over and place it up-
side down on a soft, clean surface, for
example the packaging. Otherwise, the
appliance could be scratched.
(12)
4. Insert the short, angled end of the two
enclosed retaining clamps (12) into the
slots provided on the underside of the ap-
pliance.
5. Screw down the retaining clamps using
the enclosed screws (13)
6. Place the appliance, with the sensor field
facing forward, into the worktop recess.
Align it evenly and press it firmly into
place.
Page EN-23
(13)
(12)