Increasing Or Reducing The Heat Setting Of A Cooking Zone - hanseatic MC-IF7021B2 Gebrauchsanleitung

Page EN-14 Cooking zones and sensors
-
0
- -
4. Change the heat setting for the selected
cooking zone with the slider sensor (10).
To do this, swipe your finger over the slid-
er sensor until the desired heat setting is
shown next to the cooking zone sensor.
0 = cooking zone is switched off
9 = highest heat setting
A few seconds after you remove your fin-
ger, the heat setting display stops flashing
and the cooking process begins.
-
5
- -
If you do not press a sensor or do not
place suitable cookware on the cooking
zone within one minute of switching the hob
on, the appliance will switch off automatically.
You cannot activate the slider sensor with
normally illuminated indicators before you
have selected a cooking zone.
If there is no pot, or no suitable pot, placed
on the selected cooking zone, the " " indi-
cator will appear beside the corresponding
sensor after approximately two seconds.
As soon as you place a suitable pot on the
cooking zone, the selected heat setting will
again be displayed.
In rare cases, this indicator may also appear
when there is a suitable pot. After a few sec-
onds, however, the selected heat setting will
be displayed again.
Increasing or reducing the
-
heat setting of a cooking zone
-
Even if the cooking process has already be-
gun, you can increase or decrease the heat
setting of a cooking zone.
1. Touch the sensor for the required cooking
2. To increase the heat setting for the se-
-
-
this may have several causes, for example:
– The cookware is not placed on the correct
– The cookware being used is not suitable
– The cookware is too small or is not centred
As long as there is no suitable cookware on
the cooking zone that is switched on, no heat-
ing will occur.
zone.
The indicator beside the cooking zone will
flash.
lected cooking zone, touch the slider sen-
sor (10) or swipe your finger right over the
slider sensor.
To decrease the heat setting for the se-
lected cooking zone, touch the slider sen-
sor (10) or swipe your finger left over the
slider sensor.
After a few seconds, the indicator for the
selected cooking zone will be normally illu-
minated again and the new heat setting will
have been selected.
When the " " indicator and not the
heat setting is flashing on the display,
cooking zone.
for induction hobs.
on the cooking zone.