Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
its power level and the "t" alternately.
Changing the programmed time.
For modifying programmed time,
cursor "slider" (2) of timed zone has
to be pressed. Then it will be possible
to read and modify the time.
Through sensors
(10) and
you can modify the programmed time.
Disconnecting the clock
If you wish to stop the clock before the
programmed time is up, this can be
done at any time by simply adjusting
its value to '--'.
1 Select the desired plate.
2 Adjust the value of the clock to "00"
by using the sensor
clock is cancelled. This can also be
done more quickly by pushing the
"sensors
(10) and
same time.
Power Management
Function
This model is equipped with a power
limiting function (Power Management).
This function allows the total power
generated by the hob to be set to
different values selected by the user.
To do this, for the first minute after
having connected the hob to the power
supply, it is possible to access the
power limiting menu.
1 Press the
(11) touch key for
three seconds. The letter PL will
appear on the timer indicator (12)
2 Press the locking touch key
The different power values to which
the hob can be limited will appear
and these can be changed using
the
(11) and
(10) sensors.
Fig. 11
36
3 Once the value has been selected,
once again press the locking touch
key
(6). The hob will be limited
to the chosen power value.
If you want to change the value again,
you must unplug the hob and plug it in
again after a few seconds. Thus you
will again be able to enter the power
(11),
limiting menu.
Every time the power level of a hotplate
is changed, the power limiter will
calculate the total power the hob is
generating. If you have reached the
total power limit, the touch control will not
allow you to increase the power level of
that hotplate. The hob will beep and the
power indicator (3) will blink at the level
that cannot be exceeded. If you wish to
exceed that value, you must lower the
power of the other hotplates. Sometimes
it will not be enough to lower another
(10). The
by a single level as this depends on the
power of each hotplate and the level it
is set at. It is possible that to raise the
(11) at the
level of a hotplate that of several smaller
ones must be turned down.
Fig. 10
(6).
If you use the quick switch-on at
maximum power function and the
said value is above the value set by
the limit, the hotplate will be set to the
maximum possible level. The hob will
beep and the said power value will
blink twice on the indicator (3).
Special functions:
CHEF
These functions have pre-allocated
power levels to make cooking easier,
obtaining excellent results as the
temperature of the pan is controlled
continuously by sensors. When the
target temperature for the function
has been reached, it is automatically
maintained without needing to change
the power level.
The Chef functions operate correctly
with pans with the same ferromagnetic
area on the base of the pan as the
area of the cooking zone. In addition,
for high temperature functions (above
100ºC), pans must have a flat, even
Werbung
Inhaltsverzeichnis
