Commissioning The Thicknesser; Mounting The Chip Extractor; Checks Before Putting Into Operation; Checking The Switch And Blade Brake - Parkside PADM 1250 A1 Originalbetriebsanleitung

GB IE
Make sure that the chip extractor
is suitable for the material to be
cut. This information can be found in the
operating instructions of the external de-
vice.
To dismantle, loosen the two small
screws (22). Then pull the latches (21) out
of the recesses (13) on the right and left of
the discharge table (14) and remove the
collection container (16).
Commissioning the
thicknesser
To use the machine as a thicknesser, the
following assembly work must be carried
out.
Mounting the chip
extractor
1. Loosen the small screw (22) on the left
and right latch (21).
2. If necessary, remove the collection con-
tainer with connection for external dust
extraction (16) from under the discharge
table (14).
3. Loosen the star grip screw (2) and push the
planer blade cover (25) all the way out.
4. Place the collection container (16) onto
the discharge table (14). The planer
blade (34) must be covered and the
latches (21) must engage into the re-
cesses (13) on the right and left of the
discharge table (14).
5. Insert the two latches (21) into the re-
cesses (13).
If the latches are not inserted correctly,
the machine will not start.
6. Fix the two latches by screwing in the
small screws (22).
7. Attach an external chip extractor to the
collection container (16).
28
Make sure that the chip extractor is
suitable for the material to be cut.
This information can be found in the oper-
ating instructions of the external device.
To dismantle, loosen the two small
screws (22). Then pull the latches (21) out
of the recesses (13) on the right and left of
the discharge table (14) and remove the
collection container (16).
Checks before putting
into operation
Before putting into operation, check:
- the planer blade
- the anti-kickback claws
- the functioning of the On/Off switch
- the blade brake
If any of these checks reveal damage or
improper operation, do not operate the
machine.
Checking the switch and
blade brake
On/Off switch
1. Turn the machine on using the On switch
(9) and allow it to reach full speed.
2. Turn the machine off using the Off
switch (10). The blade must come to a
standstill within 3.5 seconds. If this is
not the case, please contact the service
centre.
Checking the anti-
kickback claws
Carry out a visual inspection of the anti-kick-
back claws (24). The anti-kickback claws
must not have any visible defects and they
must all hang evenly in a row. Do not oper-
ate the machine if the anti-kickback claws
are damaged. Contact the service centre.