Original Accessories/Auxiliary Equipment; Operation; Switching On And Off; Setting The Cut Depth - Parkside PEH 30 C3 Originalbetriebsanleitung

■ Dusts can be produced while working that
are hazardous to health, inflammable or
explosive. Wear a dust mask and use a suit-
able dust/chip extractor . Some dusts are carci-
nogenic .
■ When working for extended periods of time
on wood and, in particular, materials that
produce dust which is hazardous to health,
connect the appliance to an appropriate
external dust extraction appliance. Do not
use the power planer if the battery is dam-
aged. Damaged cables increase the risk of
electric shock .
■ Do not rest your hands next to or in front of
the appliance and the area being worked.
Otherwise, there is a risk of injury if you slip .
■ In case of danger, remove the plug from the
socket immediately.
■ Always remove the plug from the power socket
in event of danger, during work breaks, when
working on the appliance (e.g. when changing
planing blade).
■ Always route the power cord towards the
rear, away from the appliance.
■
Use only sharp planing blades.
■ Do not soak the materials or the area to be
worked with liquids containing solvents.
■
Avoid all contact with rotating parts.
■ Never use the appliance for other purposes
and only with original parts/accessories.
■ Hold the appliance firmly while working.
Ensure that your stance is secure and stable .
■ The appliance must always be kept clean,
dry and free from oil and grease.
Original accessories/auxiliary equip-
ment
■ Use only the auxiliary equipment and acces-
sories specified in the operating instructions.
Using parts or accessories other than those
recommended in the operating instructions can
lead to a risk of injury .
■ 6 │ GB │ IE │ NI

Operation

Switching on and off

Switching on:
♦ First, press the safety lock-out
♦ Then press and hold the ON/OFF switch
Switching off:
♦ Release the ON/OFF switch
NOTE
► For safety reasons, the ON/OFF switch
cannot be locked .

Setting the cut depth

Use the dial to set the cutting depth in stages from
0–3 .0 mm according to the cut depth scale
Dust/chip extraction (see fig . A)
WARNING!
Always wear a dust mask!
WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance .
Adjustable chip ejector (left/right):
♦ Unlock the chip ejector
the opposite direction to the arrow (from the
"LOCK" position) .
♦ Pull the chip ejector
♦ The chip ejector
plane on the left or the right .
♦ Push the chip ejector
♦ Lock the chip ejector
position "LOCK" .
.
.
by turning it in
out of the appliance .
can be attached to the
into the appliance .
by turning it to the
PEH 30 C3
.
.