ASSEMBLY
Step 5
Note the picture!
•
Connect the computer wire (51) to the other wires, protruding from the centrepiece of the handlebar
/ instrument tube assembly (44).
•
Guide the connecting clamps at the ends of the wires into the large metal hole at the instrument
tube assembly (44). This prevents overloading of the signal line.
Put together the appropriate wire ends:
(A1 – A2), (B1 – B2), (C1 – C2), (D1 – D2) and (E1 – E2).
•
Then attach the computer (51) with the instrument tube assembly (44).
For the mounting you need:
4x cross-slitting screws M5*8
!
There is a precisely fitting screen protector on the display of your device.
If there are any scratch marks, please note that they can be on the screen protector film.
51