Emptying The Dirt Container And Cleaning The Filter; Cleaning The Appliance; Cleaning The Rotary Brush - Silvercrest SHSS 18 B1 Bedienungsanleitung

Emptying the dirt container and
cleaning the filter
NOTE
► To achieve the best results, empty the dirt
7
container and clean the HEPA filter
regularly.
► If you need a new HEPA filter
contact our customer service department
(see section Ordering replacement parts).
1) To open the dirt container
3
hand element
e
recess .
2) Press the release button
same time, pull the dirt container
and off.
3) Start by pulling the HEPA filter
6
the coarse filter
(Fig. 4). Tap out both parts over a rubbish bin
or similar. If necessary, you can rinse out the
5
HEPA filter with fresh water. Allow it to air
dry fully afterwards.
Fig. 4
4) Empty the dirt container
bin or similar.
5) First re-insert the coarse filter
5
dry HEPA filter
6) Replace the dirt container
3
element by first pushing the lower catch on
the hand element
7
container . Then, press the upper part of the
7
dirt container onto the hand element
until the dirt container
and sits firmly.
│ GB │ MT
■ 52
5
5
, please
7
, remove the
from the hand element
4
and, at the
7
forwards
5
and then
out of the dirt container
7
into the rubbish
6
and then the
.
7
onto the hand
3
into the recess on the dirt
7
clicks into place

Cleaning the appliance

Wipe the appliance with a damp cloth. For stub-
born dirt, add a little mild detergent to the cloth. En-
sure that the appliance is completely dry before
using it again.

Cleaning the rotary brush

The rotary brush
for blockages; any hair, threads or dirt should be
removed. Remove the rotary brush
1) Turn the floor nozzle upside down.
2) Push the catch on the cover plate towards
the
(Fig. 5).
3) Remove the rotary brush
4) Remove any dirt (on both sides of the brush
bristles) and clean the rotary brush
To do this, take a damp cloth and wipe the
7
individual bristle bundles from the inside to
the outside.
5) To replace the rotary brush
broad end onto the drive shaft so that the
rotary brush
6) Then, push the other end into the mount so
that the rotary brush
nozzle.
7) Reattach the cover plate until it clicks firmly into
place. The cover plate locks automatically as
the latch moves towards the
3
Fig. 5
r
should be checked regularly
symbol and remove the cover plate
r
.
r
r
hooks into place.
r
sits straight in the floor
r
as follows:
r
.
, first push the
symbol (Fig. 5).
SHSS 18 B1