Emptying The Dirt Container And Cleaning The Filter; Cleaning The Appliance; Cleaning The Rotary Brush - Silvercrest SHSS 16 A1 Bedienungsanleitung

Emptying the dirt container and
cleaning the filter
NOTE
► To achieve the best results, empty the dirt
container and clean the HEPA filter
regularly.
► If you need a new HEPA filter
contact our service department (see section
"Ordering spare parts").
1) To open the dirt container
element from the hand element recess
2) Press the release button
time, pull the dirt container
off.
3) Start by pulling the HEPA filter
coarse filter out of the dirt container
3). Tap out both parts over a rubbish bin or
similar. If necessary, you can rinse out the
HEPA filter with fresh water. Allow it to air
dry fully afterwards.
Fig. 3
4) Empty the dirt container
or similar.
5) First re-insert the coarse filter
dry HEPA filter
6) Replace the dirt container
element by first pushing the lower catch on
the hand element
container . Then, press the upper part of the
dirt container onto the hand element
until the dirt container
sits firmly.
│ GB │ MT
■ 44
, please
, remove the hand
and, at the same
forwards and
and then the
into the rubbish bin
and then the
.
onto the hand
into the recess on the dirt
clicks into place and

Cleaning the appliance

Wipe the appliance with a damp cloth. For
stubborn dirt, add a little mild detergent to the
cloth. Ensure that the appliance is completely dry
before the next use.

Cleaning the rotary brush

The rotary brush
for blockages, and any hairs, threads or dirt should
be removed. Remove the rotary brush
follows:
1) Turn the floor nozzle upside down.
.
2) Push the catch on the cover plate towards the
symbol so that you can remove the cover
plate (fig. 4).
3) Lift out the rotary brush
4) Remove dirt (on both sides of the bristles) and
(fig.
clean the rotary brush
damp cloth and wipe the individual bristle
bundles from the inside to the outside.
WARNING! RISK OF INJURY!
► Be careful when handling the knife
The blade is very sharp!
NOTE
► You can use the knife
and threads:
–
Fold the blade of the knife
the handle and cut stuck hair and threads.
–
Fold the blade back in. When doing so, only
touch the blunt edge of the blade! Risk of
injury!
–
Remove the cut hairs and threads from the
rotary brush
should be checked regularly
as
.
. To do this, take a
to remove stuck hair
carefully out of
.
SHSS 16 A1
.