Emptying The Dirt Container And Cleaning The Filter; Cleaning The Appliance; Cleaning The Rotary Brush - Silvercrest SHSS 16 A1 Bedienungsanleitung

Emptying the dirt container and
cleaning the filter
NOTE
► To achieve the best results, empty the dirt
container 8 and clean the HEPA filter 6
regularly .
1) To open the dirt container 8, remove the hand
element 4 from the hand element recess r .
2) Press the release button
time, pull the dirt container 8 forwards and
off .
3) Start by pulling the HEPA filter 6 and then
the coarse filter 7 out of the dirt container 8
(fig . 3) . Tap out both parts over a rubbish bin
or similar . If necessary, you can rinse out the
HEPA filter 6 with fresh water . Allow it to air
dry fully afterwards .
Fig . 3
4) Empty the dirt container 8 into the rubbish bin
or similar .
5) First re-insert the coarse filter 7 and then the
dry HEPA filter 6 .
6) Replace the dirt container 8 onto the hand
element 4 by first pushing the lower catch on
the hand element 4 into the recess on the dirt
container 8 . Then, press the upper part of the
dirt container 8 onto the hand element 4
until the dirt container 8 clicks into place and
sits firmly .
■ 8 │ GB │ IE │ NI │ CY
5 and, at the same

Cleaning the appliance

Wipe the appliance with a damp cloth . For stub-
born dirt, add a little mild detergent to the cloth .
Ensure that the appliance is completely dry before
the next use .

Cleaning the rotary brush

The rotary brush t should be checked regularly
for blockages, and any hairs, threads or dirt should
be removed . Remove the rotary brush t as
follows:
1) Turn the floor nozzle upside down .
2) Push the catch on the cover plate towards the
symbol so that you can remove the cover
plate .
3) Lift out the rotary brush t .
4) To replace the rotary brush t, first push the
broad end onto the drive shaft so that the
rotary brush t hooks into place .
5) Then, push the other end into the mount so
that the rotary brush t sits straight in the floor
nozzle .
6) Replace the cover plate and fasten it firmly
into place by pushing the catch towards the
symbol .
Fig . 4
SHSS 16 A1