Connecting/Removing The Hand Element To/From The Handle Rod; Operation; Using The Hand Element With The Handle Rod - Silvercrest SHSS 18 B1 Bedienungsanleitung

Connecting/removing the hand
element to/from the handle rod
Fig. 2
1) To connect the hand element
0
rod , push the tip of the hand element
into the opening in the hand element recess
e
.
2) Then press the grip
into the handle rod
3
clicks firmly into place (Fig. 2).
3) To remove the hand element
0
handle rod , press both release buttons
4) Then pull the hand element
forwards out of the hand element recess
(Fig. 3).
│ GB │ MT
■ 50
Fig. 3
3
to the handle
3
1
of the hand element
0
until the hand element
3
from the
3
upwards and
e

Operation

ATTENTION! PROPERTY DAMAGE!
► The suction opening must always be open
and may not be blocked. Blockages lead to
overheating and damage to the motor.
► Do not vacuum shag pile carpet with the floor
nozzle. The rotary brush
in the carpet and jam!
NOTE
► Make sure that the HEPA filter
coarse filter
using the appliance.
► As soon as the suction power of the appliance
begins to diminish noticeably and the charge
indicator lamp
appliance to the mains adapter
Using the hand element with the
handle rod
1) Insert the hand element
element recess
Assembly/disassembly.
2) Switch on the appliance using the On/Off
switch
lights up blue, the LED light
nozzle lights up and the rotary brush
starts rotating.
3
NOTE
► Press the ECO button
energy-saving ECO mode. The appliance
w
.
now uses a lower suction power but can run
for longer.
Press the ECO button
full suction power.
3) Guide the floor nozzle over the area to be
vacuumed. Hold the handle rod
floor nozzle moves smoothly over the floor.
4) Press the On/Off switch
finished vacuuming. The rotary brush
and the charge indicator lamp
the LED light
r
can get caught
5
6
are always inserted before
2
flashes blue, connect the
u
3
into the hand
e
as described in the section
8
. The charge indicator lamp
t
on the floor
9
to switch to the
9
again to work with
8
when you have
2
t
switch off.
SHSS 18 B1
and the
.
2
r
0
so that the
r
stops
as well as