Operation; Eco Mode; Cleaning; Emptying The Dirt Container And Cleaning The Filter - Silvercrest SHAZ 22.2 B2 Bedienungsanleitung

Operation

CAUTION!
► The suction opening must always be kept free of blockages . Blockages lead
to overheating and damage to the motor .
NOTE
► If the floor nozzle 8 is blocked so that the floor brush 0 can no longer
rotate, the appliance will switch off . The LEDs start to flash alternately . If
this happens, remove the blockage as described in the section "Cleaning
the floor brush" . Afterwards, you need to push and release the On/Off
switch q once before you can use the appliance again .
♦ If you have not already done so, disconnect the appliance from the mains
adapter g or lift it off the wall bracket f .
♦ Fit the required attachment as necessary . See also the section "Fitting/
removing attachments" .
♦ Press the On/Off switch q to switch the appliance on . As long as you hold
down the switch q, the appliance will keep running . The indicator light 3
lights up .

ECO mode

When possible, use the energy-efficient and low-noise ECO mode .
Press the ECO mode button 2 to activate ECO mode permanently .
The button lights up . This also works during operation .
Press the ECO mode button 2 again to deactivate ECO mode .

Cleaning

CAUTION! PROPERTY DAMAGE!
► Do not use aggressive, chemical or abrasive cleaning agents . These could
damage the outer surfaces of the appliance .

Emptying the dirt container and cleaning the filter

NOTE
► To achieve the best results, empty the dirt container t and clean the
HEPA filter i regularly .
♦ If you have not already done so, disconnect the appliance from the mains
adapter g or lift it off the wall bracket f .
♦ Disconnect the dirt container t from the hand element 4 by pushing the
"MOVE" u release button downwards and pulling off the dirt container t .
SHAZ 22.2 B2 GB │ MT │ 59 ■