Cpg1000 Commands For The Serial Interface; Introducing The Data Communication; General Commands; Command Description - WIKA CPG1000 Betriebsanleitung

7. CPG1000 Commands for the Serial Interface

7 CPG1000 Commands for the Serial Interface
.
7.1 Initiating the data communication
The interface communication can be established on the PC via interface software. The
connection settings should be set as follows:
The serial interface can be initiated on a PC via the interface software. The connection
settings should be set as follows:
Bits per second: 9600
■
Data bits: 8
■
Parity: none
■
Stop bits: 1
■
Flow control: none
■
Local echo on
■

7.2 General commands

Command
*CLS
FAULT?
*IDN?
TARE
TARE?
PRES_UNIT?
PRES_UNIT
ZERO_MEAS
ZERO_MEAS?
MINMAX_RST
MIN?
MAX?
HC_OFF
HC_DFLT
TEMP?
HC_COMP_OFF
HC_COMP_ON
HC_COMP?
HC_RD_2410?
WIKA Operating Instructions Model CPG1000
Description
Clears the fault queue
Returns the error code from the error queue
Identification query: returns the manufacturer, model number and
firmware version of the calibrator
Tares the offset pressure on the calibrator
Returns the current TARE value
Returns the pressure unit for the display
Sets the pressure unit for the display
Zeroes the pressure display back to zero
Returns the current zero offset value
Resets the minimum and maximum recorded pressure values
Returns the minimum pressure
Returns the maximum pressure
Turns off the CPG1000
Restores default instrument settings
Returns the temperature
Turns temperature compensation off
Turns temperature compensation on
Returns the state of temperature compensation
Returns 2410 ADC counts
GB
23