General Safety Instructions; Original Spare Parts And Accessories - EKOM DK50 2x4VR/110 Benutzerhandbuch

4. GENERAL SAFETY INSTRUCTIONS

The product is designed and manufactured so that any risks connected with its use are minimized
and the product is safe for the user and surrounding when used according to the intended use and
the instructions stated below are followed.
4.1. Required qualification of the personnel
 Each user must be trained by the manufacturer or an organization authorized by the
manufacturer or instructed on the device operation by other trained user.
 Installation, new settings, changes, extensions and repairs of the product may be performed by
the manufacturer or an organization authorized by the manufacturer (hereinafter qualified
technician).
- Otherwise the manufacturer is not responsible for safety, reliability and correct functioning
of the product.
4.2. General instructions
 When operating the compressor, all acts and local regulations valid in the place of use must be
observed. The operator and user are responsible for following the applicable regulations.
 Before every use, the user must check, if the device is functioning correctly and safely. Before
building the compressor in other devices, the supplier must assess, if the supplied air and
construction of the device comply with the requirements of the specified intended use. Taking
this into account, follow the product technical data. Assessment of conformity shall be performed
by the manufacturer – supplier of the final product.
4.3. Protection from dangerous voltage and pressure
 The equipment may only be connected to a properly installed socket connected to earth
(grounded).
 Before the product is plugged in, make sure that the mains voltage and frequency stated on the
product are the same as the power mains.
 Check for any damage to the connected compressed air system and electrical circuits before
use. Replace damaged pneumatic and electrical conductors immediately.
 Immediately disconnect the product from the mains (remove the power cord from the socket) in
hazardous situations or when a technical malfunction occurs.
 Never adjust or use the safety valve to release the air pressure in the air tank.
 Never adjust or use pressure relief valves to release air pressure from the device.
4.4.

Original spare parts and accessories

 Only the use of original parts guarantees the safety of operating personnel and flawless operation
of the product itself. Only accessories and replacement parts specified in the technical
documentation or expressly approved by the manufacturer may be used.
 The warranty does not cover damage resulting from the use of other accessories and
replacement parts as specified or recommended by the manufacturer and the manufacturer has
no related liability.
NP-DK50 2x4VR 110-AD-A-1_09-2020 8
GENERAL INFORMATION
09/2020