Minute Minder; Stopwatch; Bridge Function - AEG IAE84881IB Benutzerinformation

1. Set the heat setting for the appropriate
cooking zone first and then set the
function.
2. Touch the zone symbol.
3. Touch .
The timer menu window appears on the
display.
4. Check to activate the function.
The symbols change to
5. Slide your finger to the left or right to
select the desired time (e.g. hours and/or
minutes).
6. Touch OK to confirm your selection.
You can also choose
selection.
When the time comes to an end, a signal
sounds and blinks. Touch
signal.
To deactivate the function set the heat
setting to 0. Alternatively, touch
of the timer value, touch
confirm your choice when a pop-up window
appears.

Minute Minder

You can use this function when the hob is
activated but the cooking zones do not
operate.
The function has no effect on the operation of
the cooking zones.
1. Select any cooking zone.
The relevant slider appears on the display.
2. Touch .
The timer menu window appears on the
display.
3. Slide your finger to the left or right to
select the desired time (e.g. hours and
minutes).
4. Touch OK to confirm your selection.
You can also choose
selection.
When the time comes to an end, a signal
sounds and blinks. Touch
signal.
.
+STOP
to cancel your
to stop the
to the left
next to it and
to cancel your
to stop the
To deactivate the function touch
of the timer value, touch
confirm your choice when a pop-up window
appears.

Stopwatch

The function automatically starts counting
immediately after you activate a cooking
zone. You can use this function to monitor
how long it operates.
1. Touch to access the Menu.
2. Scroll the Menu to select Settings >
Stopwatch.
3. Touch the switch to turn the function on /
off.
The function does not stop when you lift the
pot. To reset the function and start it again
manually touch , select Reset from the
pop-up window. The function starts counting
from 0. To Pause the function for one
cooking session touch
from the pop-up window. Select Start to
continue counting.

6.8 Bridge function

This function connects two cooking zones
and they operate as one with the same heat
setting.
You can use the function with large
cookware.
1. Place the cookware on two cooking
zones. The cookware must cover the
centres of both zones.
2. Touch to activate the function. The
zone symbol changes.
3. Set the heat setting.
The cookware must cover the centres of both
zones but not go beyond the area marking.
to the left
next to it and
and select Pause
ENGLISH 15