urmet 1092/602 Bedienungsanleitung Seite 83

Option
Action
Number
LIMIT OPERATION
This option allows to store the sector coordinates.
Select LIMIT OPERATION and press the right arrow button to access the following submenu:
Option
Start Position
End Position
Direction
Operation
DS1092-090
Value
None ÷ Preset ÷
VectorScan ÷ Pattern
÷ PanScan ÷ AutoScan
Variable, according
to the value
selected on "Action"
>1Start Position ________
2End Position ________
3Direction
4Operation
IRIS CLOSE to Exit
Value
0,0 ÷ 359,9 ÷ 0,0 ÷ 90,0
0,0 ÷ 359,9 ÷ 0,0 ÷ 90,0
Left ÷ Right
ON ÷ OFF
Description
This option allows to select one of the actions
described in the previous table.
NOTE: If the selected option is None, the function
performed by the dome at power-up will be the one in
progress before the dome power-off. If, before power-
off, no programmed functions were requested to the
dome, the Park Time will be performed.
This option allows to define in detail which single
action has to be activated. The single action number
that can be selected changes according to the
previously selected action (from 1 to 165, except the
non programmable ones for the Presets; from 1 to 6 for
VectorScan; from 1 to 3 for Patterns; 1 for PanScan; 1
for AutoScan). The selection of the desired number is
possible by pressing the button OPEN and going to the
respective screen.
Limit Operation
________
________
.
Description
This option allows to store the zone coordinates
of PAN/TILT start position. By pressing OPEN and
selecting with the arrow buttons the end
position of the shot to be stored, it is also
possible to see on the monitor the coordinates
of the displayed shot. Press again OPEN to
confirm the storing of the sector start
position.
This option allows to store the zone coordinates
of PAN/TILT end position. By pressing OPEN and
selecting with the arrow buttons the end
position of the shot to be stored, it is also
possible to see on the monitor the coordinates
of the displayed shot. Press again OPEN to
confirm the storing of the sector end position.
This option allows to select the motion
direction of the dome (Left, Right).
If set to ON, this option allows to activate the
function.
83