•
Connect 230Vac power supply by putting the cable of suitable length and type (see Requirements for
connection cables) in the smallest hole provided with grommet, present on the lower side of the Power
Box and connect it to the terminal pins on the card, after removing the protection lid.
•
Put again the protection lid.
•
Close again the Power Box.
•
Fit the dome connection cable, provided, into the bracket, until it comes out on the opposite side.
•
Fix the bracket to the Power Box using the 4 screws, as shown in the figure.
•
Place on the wall mounting bracket the provided rubber o-ring, in the suitable seat.
RUBBER O-RING
LOCKING
SCREWS
DS1092-090
55
CONNECTION
CABLE
LOCKING
SCREWS