urmet 1092/602 Bedienungsanleitung Seite 80

Tilt Start POS
Tilt End POS
Name Display
NAME
Select NAME and press OPEN to access the following submenu where it is possible to give a name to the
preset:
Use the arrow buttons to move the cursor on the position where the character must be entered.
Press the button OPEN to select the desired number or letter.
Use the arrow buttons to move the cursor on the position of the desired character.
Press the button OPEN to confirm it.
To delete the character or characters previously selected, move the cursor over the symbol after
the letter Z and press the button OPEN.
Press the button CLOSE to confirm the characters previously selected and quit.
Select ON in the item Name Display to display on the monitor the sector name.
DS1092-090
0,0 ÷ 359,9 ÷ 0,0 ÷ 90,0
0,0 ÷ 359,9 ÷ 0,0 ÷ 90,0
ON/OFF
- - - - - - - - - - - - - - - -
-
0123456789ABCDEFRGHIJKLMN
OPQRSTUVWXYZ-
IRIS CLOSE When Done
This option allows to store the TILT start
coordinates of the sector. Press OPEN and with
the arrow buttons move the dome to the starting
shot to be stored. The user can see on the
display the coordinates of the displayed shot.
Press again OPEN to confirm the storing of the
sector start point.
This option allows to store the TILT coordinates
of the sector. Press OPEN and with the arrow
buttons move the dome to the ending shot to be
stored. The user can see on the display the
coordinates of the displayed shot. Press again
OPEN to confirm the storing of the sector open
point.
If enabled (ON), this function allows to see on
the monitor the name previously stored and
associated to the displayed sector.
80