urmet 1092/602 Bedienungsanleitung Seite 62

The AUTO FLIP function allows to follow an object which moves under the dome and goes straight. To do
this, keep the DOWN button pressed following the movement of the object.
10.4.2 ZOOM FUNCTIONS
The dome zoom can be changed using the commands TELE and WIDE. Use TELE command to zoom in the
image and WIDE command to zoom out the image.
Zoom can be set to the values X10 (optical) or X10 (digital), mixed between optical and digital zoom. For
further details, see the section concerning operation modes settings.
10.4.3 FOCUS CHANGE FUNCTIONS
The dome focus can be manually changed with the commands NEAR and FAR.
Because the automatic focus function (autofocus function) is always enabled and active, the manual
adjustment, configured with the commands NEAR and FAR, will be active only until the user activates a pan,
tilt or zoom command. In this case, the autofocus will automatically adjust the focus.
For further details about focus adjustment and different options, see the section concerning operation modes
settings.
NOTE
Autofocus function can not operate correctly in the following cases:
The subject is not centered in the image.
There are near and distant objects.
The object is under a strong lighting.
The object is behind a glass covered with drops or dust.
The object moves very fast.
The object is under faint lighting conditions.
The object is too big in the image.
10.4.4 IRIS OPENING FUNCTIONS
The iris can be manually opened with the commands OPEN and CLOSE.
However, if the automatic iris opening option is enabled, as by default (see the menu EXPOSURE), the
manual adjustment configured with the commands OPEN and CLOSE will be active only until the user
activates a pan, tilt or zoom command. In this case, the opening will be automatically adjusted again.
For further details about iris opening adjustment, see the section concerning operation modes settings.
DS1092-090 62