Firmware Update - Megasat Shipman Bedienungsanleitung

5. Firmware Update

When the frequency is switched off, on which the antenna idendifiziert the satellite, you
must update the firmware of the control unit.
The current firmware version of the control unit, you can read on the bottom of the
screen in the first 3 seconds after switching on.
Please check our website for the latest firmware version.
Preparing the SD card:
Before you use the SD card, format it to „FAT32"
After you format the SD card, copy the new software on it.
14
SD
CARD
ENGLISH
5. Firmware Update
Update process:
1. Turn off the controller.
2. Insert the SD card into the slot on the rear side of the control unit.
3. Turn on the control unit. The following will appear in the display:
SD CARD DETECTED
WRITING SOFTWARE
4. After the software is copied, the following message appears:
LOAD COMPLETE
5. Now switch off the control unit and remove the SD card.
6. Turn on the control unit again. The firmware is updated now.
ENGLISH
15