Gluing Instructions; Connecting The Components - Megasat Shipman Bedienungsanleitung

2. Installation
5. Roughen the drawn areas and feet with sandpaper (120 grit) to easily and thoroughly
clean the surface again with Cleaner (WARNING: then no longer touch areas) and let
the clean dry for about 10 minutes.
6. Unless you have a way to run the cable through an existing roof outlet, look for a
suitable place (best in the wind shadow behind the antenna) on the roof for the in-
stallation of a roof outlet to avoid the ingress of moisture (eg rain or splash water) in
the wellbore. Make sure that the cables are not curved too much to avoid signal loss
and damage the cable (bending radius max. 5-7 cm).

2.2 Gluing instructions

1. Prepare the glue for mounting.
2. Now take the glue on the underside of the antenna bases in
serpentine lines, so that the glue can harden well to the inside.
3. Now place immediately (within 5 minutes after adhesive appli-
cation), the antenna on the marked fields. Press your feet slightly and evenly and fix
the antenna so that it stays in place, eg by an adhesive tape. It must be after pressing
for at least 2 mm glue between antenna and surface. The adhesive is cured max. in 48
hours at +18° C and a relative humidity of 50%. Should prevail low humidity during
the assembly time, spray after bonding in the vicinity of the antenna always some
water in the air.
4. Remove any spilled adhesive immediately with a putty knife or similar and clean the
soiled surfaces with the cleaner and a fleece cloth.
5. For safety, you can attach the antenna bases additionally. Given by drill through the
existing hole in the respective antenna to the roof of your car and fix it with a screw
with locking nut. In order for the freshly bonded feet can not slip, wait with this work
until the adhesive has cured.
6. After the complete assembly and curing of the adhesive, a silicone can be drawn
around the antenna bases.
06
ENGLISH
2. Installation

2.3 Connecting the components

Install the control unit and the set-top box is not inside the vehicle in the region of an
airbag. Maintain a careful installation of the cable in order to avoid short circuits. Pay
attention also to existing cables.
Connect the antenna as shown in the illustration below:
ROT
(+)
( - )
SCHWARZ
12~24 V DC 5 A
or with the optional
power supply
230 V AC / 12 V DC 5A
Receiver
ENGLISH
07