CAUTION
L
Hot surfaces!
Burn hazard.
‣
Before commencing work: allow the system and measuring device to cool down to a
touchable temperature.
If the measuring device is removed with the cables, make sure that the cables allow
sufficient room for the measuring device to be removed.
1 →
‣
Ensure that the safety chain is properly hooked into the hot tap and sensor
fastening points and is taut.
3 →
‣
t-mass 500-digital: Hold the
sensor steady by hand. It must be
ensured that the sensor is not
able to accelerate to dangerously
high exit speeds.
Endress+Hauser
4 →
‣
t-mass 300: Open the coupling
nut slowly until the sensor can be
moved easily by hand. A small
amount of gas can escape when
the coupling nut is opened.
2 →
‣
t-mass 300: Hold the sensor
steady by hand. It must be
ensured that the sensor is not
able to accelerate to dangerously
high exit speeds.
5 →
‣
t-mass 500-digital: Open the
coupling nut slowly until the
sensor can be moved easily by
hand. A small amount of gas
can escape when the coupling nut
is opened.
EA01288D
17