Setting Ethernet Port Of Charger To Static Ip In Standalone Usage Mode; Web Configuration Interface Enable / Disable - VESTEL EVC04 Serie Installationsanleitung

2.11 - SETTING ETHERNET PORT OF CHARGER TO STATIC IP IN STANDALONE
USAGE MODE
The charging station is preconfigured to DHCP mode in factory. If you need to connect to the charging station's
web configuration interface directly using a computer, rather than using a router having DHCP server, steps
below should be followed:
• Make sure the charging station is powered-off and open the front cover of your charger which is mentioned
in installation guideline.
• Toggle the second position of DIP switch which is on the smart board of the charger shown in figure 27.
After that please turn on the charger again.
• Charging station sets the Ethernet port to 192.168.0.10 adress statically and subnet mask will be set to
255.255.255.0
If the charger's LAN interface is needed to be set back to DHCP mode again this can be done from the web
configuration interface.
Note: You can also use factory reset function to set the LAN interface back to DHCP mode again but please well
note that all other parameters will be set to factory default parameters.

2.12 - WEB CONFIGURATION INTERFACE ENABLE / DISABLE

If you need to enable/disable the Web Configuration interface below steps should be followed:
• Make sure the charging station is powered-off and open the front cover of your charger which is mentioned
in installation guideline.
• If you want to enable the web configuration interface, third position of DIP switch should be in "OFF"
position as shown in figure 28.
• If you want to disable the web configuration interface, third position of DIP switch should be in "ON" position
as shown in figure 28.
IG v7.3.0 2021
Toggle
Figure.27
Figure.28
© 2021 Vestel - All rights reserved
6 5 4 3 2 1
ON
OFF
6 5 4 3 2 1
ON
ON
English - 32