Wall Mount Installation - VESTEL EVC04 Serie Installationsanleitung

2.2 - WALL MOUNT INSTALLATION

Wall mount installation is common for all charging station models.
1- Open the product front cover by following the instruction in section 2.1.
2- Place the charging station to the Wall by using the mounting template which is given in accessory
bag and mark the drill bit holes with a pencil.
3- Drill the wall on the marked points using the impact drill (8mm drill bit).
4- Place the dowels into the holes.
5- Tighten the security scews (6x75) of the product using Torx T25 Security Screwdriver.
6- Insert the AC mains cable into the charging station from the left cable gland which below the
station. Follow the AC Mains Connection instructions on the next pages, see section 2.3 or 2.4
depending on the model of the charger. (Single/Three Phase)
7- In case you mount the charging station to conductive metal surface such as metal pole etc...,
you can make ground connection via "right-bottom" screw using ground extension cable as shown
in figure-6. To ensure the grounding, you need to change the grounding cable position from "a" to
"b" as shown in figure-6. Follow the instructions below:
i. Insert the plastic support (IP rubber which is given inside accessory pack of the unit), to the
fixing hole (Position "b")
ii. Fix the grounding cable using M6x30 screw, which is inside the artwork pack and this screw
is also used to assemble to product to the conductive metal surface.
8- Tighten the cable glands as shown in the figure. Before closing the cover of the charging station,
follow the instructions in sections 2.6 and 2.7 if any function related to these sections are used.
NOTE : Also check section 4 (Commissioning).
9- To close the cover of the charging station, tighten the cover screws which you were removed
with Torx T20 Security L-Wrench or Right Angle Screwdriver Adapter using Torx T20 Security Bit.
10- Mounting the charging station on the wall is finished.
3
Before next step (7), Please check the instructions for Single Phase or
Three Phase cable connections in sections 2.3 or 2.4.
IG v7.3.0 2021
1
4
Figure-5
© 2021 Vestel - All rights reserved
2
5
6
English - 15