Commissioning - VESTEL EVC04 Serie Installationsanleitung

12- Insert the RJ45 connector to the socket as shown in figure below.

4 - COMMISSIONING

If you want to connect the charging station's web configuration interface, you have two options;
a. You can directly connect your PC to the charging station using a patch Ethernet cable. If you fol-
low this option, please make sure that you have properly configured your charging station's LAN
interface to static IP by following steps in section 2.11 - SETTING ETHERNET PORT OF CHARG-
ER TO STATIC IP IN STANDALONE USAGE MODE and your charging station's web configuration
interface is enabled via DIP switch which is mentioned in section 2.12 – WEB CONFIGURATION
INTERFACE ENABLE / DISABLE. By default, web configuration interface is enabled.
b. You can use a router having DHCP server. In this option, both the charging station and the PC
should be connected to the router. Please be sure that you need to check the IP adress from the
router to be able to make the connection.
For direct PC connection option, you need to connect your PC to the charging station to use func-
tions and make configurations below:
• Login
• Change Password
• Main Page
• General Settings : Display Language
• OCPP Settings : OCPP Connection,OCPP Version,Connection Settings,OCPP Configuration
Parameters
• Network Interface Settings:Cellular,Ethernet,Wi-Fi
• Standalone mode settings
• System Maintanence:
• Log Files,Firmware Updates,Configuration BackUp&Restore,System Reset,Administration
Password,Factory Default Configuration
IG v7.3.0 2021
Table-15
© 2021 Vestel - All rights reserved
CN13
English - 35