Data Cable Connection - VESTEL EVC04 Serie Installationsanleitung

2.6.1 - DATA CABLE CONNECTION

1- Remove rubber cork from cable gland.
2- Insert cable through the cable holes.
3- Insert the cable through the RCCB housing holes.
4- Finally, to connect the wires on mainboard, check the following sections in 2.6 and 2.7 depending
on the function(s) to be used.
NOTE : Below data connection cables can be inserted through the cable holes;
a. External enable input cable
b. Power optimizer measurement cable
c. Ethernet daisy chain connection cables (Optional)
d. Load shedding triggering signal cable
e. Shunt trip module control signal cable for welded relay contact failure
IG v7.3.0 2021
1
3
© 2021 Vestel - All rights reserved
2
Figure-13
1
3
English - 22