Preset Selection; Presets - VESTEL EVC04 Serie Installationsanleitung

Main Page of E.ON Auto-detect variants:

6.1.1 - PRESET SELECTION

Products have preset configurations which makes it easier to install and change configurations
of the products in the field. Preset selection can be done from the drop down menu on main page
of web configuration interface, as shown in figure below.

6.1.2 - PRESETS

a.E.ON Auto-detect: This preset is only available for the products as mentioned in table in section
5.2. E.ON Auto-detect preset automatically selects LAN or cellular interface with higher priority on
LAN interface. This means if the LAN interface is physically connected and it has IP adress, then
the charging station tries to connect from LAN interface to the OCPP central system using VPN
link. If LAN interface is not connected or does not have IP adress, then the charging station tries to
connect via cellular interface using VPN link. The charging station is preconfigured as plug&charge
by default. To disable plug&charge mode (VestelFreeMode) and activate RFID authorization, it is
needed to change FreeModeActive OCPP configuration key to "false" either from OCPP central
system or from web configuration interface in "OCPP Settings" menu.
b.Standalone: This preset is available for both Standalone and E.on Auto-detect products as
mentioned in table.2. In Standalone preset, the charging station is configured for standalone
plug&charge usage and deactivates connection to OCPP central system. This preset is mainly for
local usage purposes. In this preset, it is possible to use factory registered master RFID card for
adding/deleting user RFID cards to the local list of charging station. By adding user RFID cards
IG v7.3.0 2021
Figure.37
Figure.38
© 2021 Vestel - All rights reserved English - 40