Resetting Local Rfid Card List And Registering New Master; Rfid Card In Standalone Usage Mode; Setting Ethernet Port Of Charger To Static Ip In Standalone; Usage Mode - VESTEL EVC04-Serie Installationsanleitung

2.10 - RESETTING LOCAL RFID CARD LIST AND REGISTERING NEW MASTER

RFID CARD IN STANDALONE USAGE MODE

If you loose your master RFID card and need to define a new master RFID card, below steps
should be followed by your authorised service technician.
• Make sure the charging station is powered-off and open the front cover of your charger
which is mentioned in installation guideline.
• Toggle the first position of dip switch which is on the smart card of the charger shown in
figure 26. After that please turn on the charger again.
When the charger re-energised, please note that;
• Previously stored master card and user card list, if any exists, are deleted from charging
station while entering the configuration mode.
• If master card had not been registered during 60 seconds then configuration mode expires
and charging station behaves as autostart product.
• The first RFID card which is registered within this 60 seconds of duration will be the new
master RFID card. Please follow instructions to register RFID user card which is used
during charging process.

2.11 - SETTING ETHERNET PORT OF CHARGER TO STATIC IP IN STANDALONE

USAGE MODE

If you need to set the Ethernet port of your charger to static IP, below steps should be followed:
• Make sure the charging station is powered-off and open the front cover of your charger which is mentioned
in installation guideline.
• Toggle the second position of dip switch which is on the smart card of the charger shown in figure 27. After
that please turn on the charger again.
• Charging station sets the Ethernet port to 192.168.0.10 adress statically and subnet mask will be set to
255.255.255.0
IG v7.3.0 2021
Toggle
Figure.26
© 2021 Vestel - All rights reserved
ON
1 2 3 4 5 6
English - 32