Factory Reset; Resetting Local Rfid Card List And Registering New Master; Rfid Card In Standalone Usage Mode - VESTEL EVC04 Serie Installationsanleitung

2.9 - FACTORY RESET

You must push the button on HMI board shown in figure-24 for factory reset. When you hold
the button for 5 seconds user configuration will be reset to factory configuration. (e.g OCPP
config, Network Config will be back to factory configuration.)

2.10 - RESETTING LOCAL RFID CARD LIST AND REGISTERING NEW MASTER

RFID CARD IN STANDALONE USAGE MODE

If you loose your master RFID card and need to define a new master RFID card, below steps
should be followed by your authorised service technician.
• Make sure the charging station is powered-off and open the front cover of your charger
which is mentioned in installation guideline.
• Toggle the first position of DIP switch which is on the smart board of the charger shown in
figure 26. After that please turn on the charger again.
When the charger is powered on again please note that;
• Previously stored master card and user card list, if any exists, are deleted from charging
station while entering the configuration mode. In configuration mode, the charger indication
LED blinks red.
• If master card had not been registered during 60 seconds then configuration mode expires
and charging station behaves as autostart product.
• The first RFID card which is registered within this 60 seconds of duration will be the new
master RFID card. Please follow instructions to register RFID user card which is used during
charging process.
IG v7.3.0 2021
Figure-24
Toggle
Figure.26
© 2021 Vestel - All rights reserved
SW4
6 5 4 3 2 1
ON
English - 31