Connecting The Device; Protecting The Device From Defects - Imperial DABMAN PBB 2 Bedienungsanleitung

2. SAFETY INSTRUCTIONS
> In this case, pull the power adapter out of the power socket immediately.
> Only handle the power adapter by the casing.
Never pull the power adapter out of the socket by the cable.
After a malfunction, the device must not be used until it has been checked or repaired by a qualified
person.
> If you bring the device from a cold to a warm environment, moisture can form inside the device.
In this case, wait about an hour before using it.
> Unplug the device from the power socket if you are absent for a longer period or during a
thunderstorm.
Make sure that contact with moisture, water or spray is avoided and that no objects filled with liquids -
e.g. vases - are placed on or near the appliance or power adapter.
> If foreign bodies or liquids get into the device or the power adapter, pull the power adapter out of
the socket immediately. Have the device checked by qualified personnel before you use it again.
Otherwise, there is a risk of electric shock.
> Make sure that the device and the power adapter are not exposed to dripping or splashing water
and that there are no naked flames (e.g. burning candles) near the device or the power supply.
> The power adapter must never be touched or handled with wet or damp hands.

2.4 Connecting the device

> Only connect the device to a properly installed, earthed and electrically protected socket.
> Please ensure that the power source (socket) is easily accessible.
> Do not kink or crush any cable connections.
> Before using the device,
check whether the voltage specification on the device corresponds to local mains voltage.
The information on the power adapter must correspond to the local mains supply.
> Only connect the radio to a properly installed socket with 220–240 V AC at 50–60 Hz.
> Place the radio on a firm, level surface.
> The device consumes power in standby mode. To fully switch off the device, the plug must be pulled
from the socket.

2.5 Protecting the device from defects

PLEASE NOTE!
> Unfavourable environmental conditions such as moisture, excessive heat or lack of ventilation can
damage the device.
> Only use the device in dry rooms.
Avoid the direct vicinity of: heat sources, such as radiators, naked flames such as candles and devices
with strong magnetic fields such as speakers.
Do not expose the device to extreme conditions, e.g. direct sunlight, high
humidity, moisture, extremely high or low temperatures, naked flames.
> Ensure that there is sufficient distance from other objects so that the device is not covered and
38 DE