Installation; Power Supply; Switching On For The First Time - Imperial DABMAN 100 Bedienungsanleitung

5. INSTALLATION

Please carefully remove the parts from the packaging. Check whether all parts are
E D
present. Now carefully pull the plastic safety strip from the battery compartment
on the underside of the remote control, so that the power supply for the remote
control is established.
Note:
The radio can be controlled both via the keys on the unit and via the remote control.
Using the remote control is the more convenient and easier way of controlling the
DABMAN 100. For this reason, this operating manual focuses mainly on operating
the radio via the remote control supplied.

5.1. Power supply

First, connect the adapter cable supplied with the appropriate socket on the rear
side of the DABMAN 100 (see ill.)
Reverse side in Chapter 4.2.). Now connect the mains adapter with a 220V mains
outlet. Then extend the telescopic antenna at the back of the radio to its full length
to ensure the best possible reception.
The display of the radio will now be blinking, the lower section will display the mes-
sage "Time is not set".

5.2. Switching on for the first time

Press the red Standby key on the remote control unit. The radio will start playing
in DAB+ mode, and will switch automatically to the time transmitted via DAB+. At
the same time, the radio will perform an automatic station scan. As soon as this is
completed, and the DABMAN 100 is receiving stations, the radio will commence
playing the first DAB+ station found.
The radio is now ready for use. To adjust the DABMAN 100 in accordance with
your preferences, you can make adjustments to the radio via the menu.
Note:
If the radio was unable to find any programmes during the automatic station scan,
please press the Mode key to select the "FM" mode.
You are now in FM radio mode. Press the scan key to scan the frequency range
(87,5 – 108 MHz) for radio stations.
33