Removing Jammed Staples; Maintenance - Parkside PDT 40 F4 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Operation / Maintenance
If the fastener is too deep, decrease the

air pressure in steps of 0.5 bar.
Alternatively, you can speed up opera-

tion by holding the trigger
Place the air stapler on the workpiece.

Press the device onto the workpiece until

the mouth 11 touches the workpiece.
The fastener leaves the device.
As long as you keep the trigger

pressed, then, every time the mouth
touches the workpiece, then a fastener
will leave the device.
Alternatively you can also keep the

11
mouth of the device pressed continu-
ously onto the workpiece.
Every time you press the trigger

fastener leaves the device.
In all cases you should endeavour to work
with the lowest level of air pressure. This
brings you three signifi cant advantages:
1) You save energy,
2) You reduce the noise level,
3) You reduce the wear on the fastening
device.
Avoid triggering the fastening device when
the magazine is empty. If the fastening
device is defective or is not working
properly, disconnect it immediately from
the compressed air and hand it over to
an expert for inspection. During long
work breaks or when work has fi nished,
disconnect the device from the compressed
air system and ideally empty the magazine.
Protect the compressed air connections of
the fastening device and the hose lines
against contamination. Penetration of
coarse dust, chips, sand, etc. leads to leaks
and damage to the fastening device and
couplings.
NOTE: It is also possible to carry out
fi ne-tuning using the knurled screw
46 GB/IE

2
pressed in.


2
11

 Removing jammed staples
2 one





 Maintenance
Always disconnect the
device from the compressed
air supply and empty the
magazine before cleaning
and/or carrying out main-
tenance work.
9
.
Rotate the knurled screw
make the fastener go deeper into the
workpiece.
Rotate the knurled screw
the fastener go less deep into the
workpiece.
Rotate the exhaust air outlet
the exhaust air fl ow point in the direction
you want.
Disconnect the device from the compres-
sor after completing work.
If a staple/nail has got stuck in the
magazine shaft, remove the compressed
air supply immediately.
Open the magazine
the "Load magazine" chapter.
Open the face plate
quick clamp lever for the face plate
in the direction of the trigger safety
catch 10 .
Remove the jammed fastener. Close the
face plate 12 by pulling the quick clamp
lever for the face plate
of the exhaust air outlet
Close the magazine
as described in the "Load magazine"
chapter.
DANGER OF INJURY!
9 down, to
9
up, to make
1 , to guide
7
as described in
12
by pulling the
13
13
in the direction
1
.
7
of the air stapler,