Original Accessories/Attachments; Before Use; Charging The Battery Pack; Inserting/Removing The Battery Pack - Parkside PAR 12 A1 Originalbetriebsanleitung

Original accessories/attachments

■ Use only the additional equipment and acces­
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc-
tions can lead to a risk of injury .

Before use

Charging the battery pack

CAUTION!
► Always disconnect the mains plug before
removing or inserting the battery pack 4
from the high-speed charger 0 .
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C .
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level
is between 50% and 80% . The storage climate
should be cool and dry and the ambient
temperature should be between 0°C and
50°C .
♦ Insert the battery pack 4 into the high-speed
charger 0 .
♦ Insert the mains plug into the mains socket .
The control LED w lights up red .
♦ The green LED q indicates that the charging
process is complete and the battery pack is
ready for use .
♦ Push the battery pack 4 into the appliance .
♦ You should always switch the high-speed
charger 0 off for at least 15 minutes between
successive charging processes . Also disconnect
the power plug from the mains power socket .
PAR 12 A1

Inserting/removing the battery pack

Inserting the battery pack
♦ Snap the battery pack 4 into the handle 2 .
Removing the battery pack
♦ Press the two release buttons 3 and remove
the battery pack 4 .

Checking the battery charge level

♦ Press the ON/OFF switch 5 to check the
charge level of the battery .
The status/remaining charge will be shown on
the battery charge level display 1 as follows:
RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery

Use

Select direction of rotation

WARNING!
► The rotation direction switch 9 may only
be used/adjusted when the appliance is at a
standstill .
♦ Select the direction of rotation by moving the
rotation direction switch 9 to the right or left .

Switching on/off

Turn on
♦ Press and hold down the safety lock-out 6 .
Then press and hold the ON/OFF switch 5 .
Once the machine is running, you can release
the safety lock-out 6 . The LED work light 7
lights up when the ON/OFF switch 5 is
pressed lightly or fully .
This provides illumination of the work area in
poor lighting conditions .
GB │ MT │ 43 ■