Motor Unit With Multisander Attachment Pkga2; Attaching/Removing Sanding Sheet; Selection Of Sanding Sheet - Parkside PKGA 20-Li C2 Originalbetriebsanleitung

GB MT
The necessary torque is dependent on:
- the type and hardness of the ma-
terial to be treated;
- the type and length of the screws
used.
Motor unit with
multisander
attachment PKGA2
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Wear a protective mask during
grinding work.
Attaching/removing sanding
sheet
The sanding plate (21) is fitted with Velcro for
rapid attachment of the sanding sheet.
Attaching sanding sheet
1. Press the sanding sheet (23) evenly onto
the sanding plate (21). Ensure that the
holes in the sanding sheet are placed
above the openings in the sanding plate.
Removing sanding sheet
2. Simply pull the sanding sheet (23) off
the sanding plate (21).
Connecting dust extraction
You can reduce dust production during sand-
ing by attaching a dust extraction system.
1. Push the adaptor (24) into the opening
on the multi-sander attachment (22) as
far as the stop.
2. Connect a dust extractor suction hose
to the adaptor (24).
82
Make sure that the dust extraction sys-
tem is suitable for the material to be
cut. This information can be found in
the operating instructions of the exter-
nal device.
If necessary, you can connect the suc-
tion hose of a vacuum cleaner with-
out reducer (25) to the adapter (24).
Sanding
• Use a dust extraction system when sand-
ing with the multi-sander attachment.
• Move the appliance against the work-
piece once it is switched on.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work using low and even pressure.
This protects the appliance and the
sanding sheet.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).

Selection of sanding sheet

Grain size P Application
for pre-sanding rough wood
P 60
surfaces
P 80 / 120 for plain sanding
for fine sanding of primed
P 240
and painted surfaces