Fitting The Chisel; Removing The Chisel; Use - Parkside PAH 1700 A1 Originalbetriebsanleitung

fitting the chisel

WARNING!
► Use only an appropriate hexagonal shaft
chisel with a diameter of 30 mm .
► Before every use, check whether there is
enough grease in the appliance and on the
chisel (see section "Greasing") .
Operation without grease will cause irrepa-
rable damage to the appliance .
♦ Pull out the locking pin
tion so that it does not block the tool holder
The flat side of the locking pin
upwards to open the tool holder
Fig. 2
♦ Place the chisel
pointing in the direction of the locking pin
(see fig . 2) .
♦ Turn the locking pin
groove on the locking pin
the tool holder and it audibly clicks into
place . This locks the tool holder
ed side of the locking pin
Check that the chisel
in place by pulling it . The system has radial play
because of the design .
NOTE
► If the locking pin
position, this means that the chisel
not in the correct position .
Move the machine into a vertical position
and then press the chisel
floor . You can now rotate the locking pin
■ 18 │ GB │ IE
and lock it into posi-
must point
.
/ with the milled groove
180° until the small
points away from
. The round-
points upwards .
/ is properly locked
cannot be locked into
/
/ towards the

Removing the chisel

WARNING! RISK Of INjuRy!
► The chisel can become very hot during opera-
tion . Allow the chisel to cool down after use
and always wear protective gloves when you
are removing the chisel .
Pull out the locking pin
so that it does not block the tool holder
The flat side of the locking pin
upwards to open the tool holder
.
♦ Pull the chisel

use

WARNING! RISK Of INjuRy!
► The chisel can jam during use and this can
transfer powerful forces into the handle .
Always ensure that you are standing securely
and have a firm grip during operation .
► Ensure that the appliance is switched off
before plugging it in .
WARNING!
► Before every use, check whether there is
enough grease in the appliance (see section
"Greasing") .
Operation without grease will cause irrepa-
rable damage to the appliance .
► Before operating the appliance, check
whether there is enough oil in the appliance
(see section "Checking the oil level") . Opera-
tion without sufficient oil will cause irrepara-
ble damage to the appliance .
► Do not apply excessive pressure when
working with the appliance . This reduces the
performance and puts added strain on the
motor .
is
.
and lock it into position
.
must point
.
/ out of the tool holder
PAH 1700 A1
.